Installing the LED TV Stand
Installing the Wall Mount Kit
Wall Mount Kit Specifications (VESA)
Quick Setup Guide
See separate guide for installing the stand.
Wall mount items (sold
Install your wall mount on a solid wall perpendicular to the floor. When attaching
to other building materials, please contact your nearest dealer. If installed on a
ceiling or slanted wall, it may fall and result in severe personal injury.
➣ Standard dimensions for wall mount kits are shown in the table below.
➣ When purchasing our wall mount kit, a detailed installation manual and all
parts necessary for assembly are provided.
➣ Do not use screws that do not comply with the VESA standard screw
specifications.
➣ Do not use screws that are longer than the standard dimension or do not
comply with the VESA standard screw specifications. Screws that are too
long may cause damage to the inside of the TV set.
To register this product please visit
separately) allow you to mount
the TV on a wall. For detailed
information on installing the
wall mount, see the instructions
(A)
(B)
5EA (M4 X L12)
5EA (M4 X L8)
s
s
s
s
s
provided with the Wall Mount
items. Contact a technician for
assistance when installing the
Blanking Bracket
Stand (1EA)
Guide Stand (1EA)
Screws (10EA)
wall mounted bracket. Samsung Electronics is not responsible for any damage
to the product or injury to yourself or others if you select to install the TV on your
own.
List of Parts
Follow the steps below to connect the TV to the stand.
1
2
6
3
7
4
➣ For wall mounts that do not comply with the VESA standard screw
specifications, the length of the screws may differ depending on the wall
mount specifications.
➣ Do not fasten the screws too strongly; this may damage the product or
cause the product to fall, leading to personal injury. Samsung is not liable
for these kinds of accidents.
Screws (M4 X L12)
Top view
➣
Remove the stand and cover the bottom hole with the cover.
(M4xL8)
s
s
2
s
s
Guide Stand
s
s
5
s
s
s
s
s
s
Stand
s
s
➣ Samsung is not liable for product damage or personal injury when a non-
VESA or non-specified wall mount is used or the consumer fails to follow
the product installation instructions.
➣ Our 57” and 63” models do not comply with VESA Specifications. Therefore,
you should use our dedicated wall mount kit for this model.
➣ Do not mount the TV at more than a 15 degree tilt.
1
Rear
1
3
5
7
Remote Control & Batteries (AAA x 2)
Cleaning Cloth
Data Cable (BN39-00865B, BN39-01011B)
2
4
6
Power Cord
Blanking Bracket
Stand & Screw (M4xL16)
1. Connect the Guide Stand
to the Stand using four
screws (M4 X L12) as
shown.
2. With your TV upright,
connect the TV to the
Stand as shown.
3. Fasten two screws (M4
X L8) at position , and
then fasten three screws
(M4 X L8) at position
1
Warranty Card / Safety Guide (Not available in some locations)
➣
Always use two people to mount the TV to a wall.
2.
3
1
4
2
5
0
VESA Spec.
(A * B)
Product
Family
Standard
Screw
✎
NOTE
inches
Quantity
Make sure to distinguish between the front and back of the Stand and Guide
Stand when assembling them.
x
7
8
9
6
19 ~ 22
23 ~ 29
32~37
75 X 75
M4
200 X 100
200 X 200
400 X 400
600 X 400
Make sure that at least two persons lift and move the LED TV.
x
x
LED TV
[Ultra-Slim]
4
M8
Stand the product up and fasten the screws. If you fasten the screws with the
LED TV placed down, it may lean to one side.
1
4
7
Holder-Wire Stand
Holder-Ring (4EA)
AV Adapter
2
5
8
Cable Tie
Power Cord Clamp
Audio Adapter
3
6
9
Holder-Wire (3EA)
Component Adapter
AV Adapter
40~55
56~65
(Aus, Singapore, NZ only)
SCART Adapter
(EU, Mideast Africa only)
(Aus, Singapore, NZ only)
Do not install your Wall Mount Kit while your TV is turned on.
It may result in personal injury due to electric shock.
0
BN68-02879E-X0
Viewing the Connection Panel
1
2
3
4
5
6
7
8
9
0
!
RJP
EU Hotel (4000)
Mideast Africa Hotel (4000)
Aus, NZ, Singapore Hotel (4000)
USB (HDD) / CLONING
COMMON INTERFACE
HDMI IN 1(DVI), 2
PC / DVI AUDIO IN
PC IN
1
2
1
2
1
2
#
3
$
%
$
%
COMPONENT IN
AV IN
Power Input
Power Input
Power Input
4
5
4
5
4
5
EXT(RGB)
ANT IN
DATA
-
Used to support data communication between the TV and the SBB.
@
!
0
9
8
7
6
4
@
!
0
8
7
7
6
4
@
!
0
9
8
7
6
4
@
#
Power input
AV OUT
-
AUDIO OUT
-
VIDEO OUT
(DTV signal is unsupportable. This output is only for Analogue video signal.)
$
%
Headphones jack
HP-ID
[QSG]BN68-02879E-Hotel.indd
1
2010-04-13 오전 10:04:33
|