5KPING"$GNN"9KTGNGUU"&QQT"%JKOG
63-1123
OWNER’S MANUAL — Please read before using this equipment.
"+/2146#06"
#
#
If an icon appears at the end of a paragraph,
go to the box on that page with the
Transmitter
Receiver
corresponding icon for pertinent information.
Indicator — Lights when
BELL is pressed.
— Warning
° — Hint
± — Note
Rý
. — Caution
— Important
#
Slide ON/OFF to ON
BELL — Press BELL
so that when BELL
to hear the door
is pressed on the
chime.
transmitter, a door
chime sounds.
Thank you for purchasing the RadioShack
Single Bell Wireless Door Chime. It works as
a doorbell, remote pager, or alert. You can
add an optional external sensor to have a
chime that alerts you when someone walks
into a room. The door chime’s three-position
channel switch prevents other transmitters
or radio devices from sounding the chime.
/1706+0)"6*'"
4'%'+8'4
10"#"(.#6"574(#%'
4. Drive a screw through the holder into
each hole.
Pull out the wire stand on the back of the
receiver and set it on a table or other flat
surface.
5. The transmitter can be slid in and out of
the holder. To lock the transmitter, fix it
with a size M2.6 screw at the bottom of
the holder.
10"#"9#..
1. Drill one 3/16-inch diameter hole and
insert one of the supplied anchors.
+056#..+0)"
2. Drive the supplied M3.5 screw into the
hole until the screw's head extends
about 1/8 inch from the wall.
$#66'4+'5"#0&"
5'.'%6+0)"%*#00'.5
."%#76+10".
• Use only fresh batteries of the required size
and type. Always remove old or weak
batteries. They can leak chemicals that
destroy electronic circuits
3. Align the keyhole slot on the bottom of
the receiver with the screw in the wall,
then slide it down to secure it.
The door chime requires three AAA batteries
in the transmitter and three C batteries in the
receiver. For best performance and longest
life, we recommend RadioShack alkaline
batteries. .
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
/1706+0)"6*'"
64#05/+66'4"
+0"6*'"64#05/+66'4
1. Remove the transmitter from the holder.
1. Slide the transmitter's battery
compartment door in the direction of the
arrow to remove it.
2. Use the holder as a template to mark
two screw holes on the wall.
2. Use a small flat-blade screwdriver to
slide the switch inside the battery
compartment to the desired channel for
the transmitter.
3. Remove the holder from the mounting
surface and drill two 3/16 inch diameter
holes. Insert one of the supplied
anchors into each hole.
© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
|