Step Four
Measuring Blood Pressure
Wrist Cuff Blood
Pressure Monitor
63-1515
1. Press START/STOP. All display segments
appear briefly, the systolic rate rests to 00,
and appears. The pressure cuff
Â
Step One
Install Batteries
automatically inflates to 195 mmHg or the
sufficient pressure level for measurement.
The systolic rate varies, and ♥ flashes at
the same rate as your heartbeat.
1. Remove the battery compartment cover.
2. Insert two AAA batteries as indicated by
the polarity symbols. For easy removal,
place the ribbon under both batteries.
2. Once the monitor detects your blood
pressure reading, the pressure cuff deflates
slowly. Your blood pressure reading and
pulse rate appear.
3. To stop measurement, press START/STOP.
à appears for about five seconds when:
Step Three
Attaching the Pressure Cuff
•
The pressure cuff is not wrapped around your wrist
correctly.
•
•
You move or talk during measurement.
You do not have correct posture.
1. With your palm face up, wrap the pressure cuff snugly around
3. Replace the cover.
3
13
When the display dims or batteries weaken,
your wrist, leaving about /16 inches to /32 inches (0.5 to 1 cm)
clearance between the wrist and the cuff.
Áappears on the display. Replace the batter-
ies.
Step Five
2. Place your elbow on the table and wrist against the armrest or
the storage case so the pressure cuff is at the same height as
your heart.
Step Two
Setting the Date and Time
Recalling Stored Readings
1. Press RECALL. The last reading with the
1. Press MODE. The month digit flashes.
date and time appears.
2. Repeatedly press (or hold down) SET to set
2. Repeatedly press (or hold down) RECALL
the correct month.
to view other stored readings (up to 48).
3. Repeat Steps 1 and 2 to set the date, hour,
3. To view current date and time, repeatedly
press or hold down RECALL until the current
date and time appear.
and minute. Press MODE when finished.
What’s Included
4. To erase all stored readings, remove and
reinstall the batteries.
•
Wrist Cuff
•
Storage Case
•
Monitor
|